|
view |
Is there any port for an NXP Cortex evaluation board that support the .Net Micro Framework? Is NXP or any third party supporting the .NET Micro Framework? |
2012-11-21 15:56 |
|
view |
about the u-boot-2011.06 for lpc1788! |
2012-02-16 10:02 |
|
view |
After a software reset like WD reset, BOD reset, is the SRAM content retained? |
2012-12-04 12:13 |
|
view |
Are the LCD controller signals LVDS? |
2012-11-20 16:17 |
|
view |
Are there any DSP libraries available for the Cortex-M3 microcontrollers ? |
2012-11-27 00:30 |
|
view |
Assuming I am using the EMC for both accessing the LCD buffer and external flash, where I have my executable code stored, how will execution time be affected? |
2011-07-14 08:36 |
|
view |
DMAReqSel on LPC17xx indicates UART0/MAT0.0, can both be used simultaneously to trigger a DMA request? |
2012-12-11 15:35 |
|
view |
Do the CAN controllers on LPC17xx have a Time Stamp function ? |
2012-11-27 00:25 |
|
view |
Do the CAN controllers on LPC17xx have a Time Stamp function ? |
2012-11-27 00:25 |
|
view |
Do the LPC17xx and LPC18xx have USB Flash loader like the LPC1343? |
2012-12-11 15:29 |
|
view |
Do you have size limit or memory size calculator to help set the size of the frame buffer? |
2012-11-20 16:28 |
|
view |
Has FatFS been ported to the LPC17xx ? |
2012-11-27 00:07 |
|
view |
How can I identify the Ethernet MAC ID to differentiate between 23xx/24xx/17xx? |
2012-12-11 15:30 |
|
view |
How can software detect that the external oscillator does not work, and it should use the internal RC oscillator instead, and report this as an error? |
2012-11-21 15:58 |
|
view |
How do I configure Lpcxpresso to place code in RAM? |
2012-11-21 16:07 |
|
view |
How is the LPC2478 32-bit External Memory Controller different than the LPC1788 32-bit External Memory Controller? |
2013-04-01 13:32 |
|
view |
How long can short-circuit output current flow before damaging the microcontroller? |
2012-11-21 16:12 |
|
view |
How many breakpoints and watchpoints are supported on LPC17xx and other Cortex-M3 devices? |
2012-11-19 13:24 |
|
view |
How should the VBAT and RTCX1 pins on LPC17xx be configured when the RTC is not used? |
2012-11-19 13:22 |
|
view |
How to calculate the value of crystal load capacitors? |
2012-12-21 14:25 |
|
view |
If the LCD controller has a lower priority on the EMC bus, refreshes will be stalled. How noticable is this on the screen? |
2012-11-20 16:33 |
|
view |
In the case where a UART Framing error occurs, is it possible to Reset/Restart the UART core after detecting this Framing error? |
2012-12-11 15:28 |
|
view |
Is it feasible to run the LPC1788 at 1024x768 at 24bpp? Or, does the bus width mitigate the maximum resolution at 24bpp and/or maximum color depth at 1024x768? |
2012-11-20 16:36 |
|
view |
Is it possible to sample two analog signals at the same time on a Cortex-M3 device? |
2012-11-19 13:30 |
|
view |
Is the frame buffer inside the 1788 or in an external device? |
2012-11-20 16:39 |
English
简体中文
